PACE Pro is compatible with 22mm bands. The bands attach with a quick release mechanism, so you can conveniently swap your current band for a new one.
Changing the silicone band
To remove the silicone band from PACE Pro, slide your fingernail against the quick release lever on the back of the watch band. Once the lever is pressed all the way, the edge of the quick release bar will release, and you can then pull the band away from the watch body.
When placing a new silicone band on your watch, notice that the edges of each band are specifically shaped to fit flush against the watch body. Make sure to orient the band so it matches with the grooved space between the watch lugs. Then use your fingernail to slide the quick release lever on the band. Once the lever is pressed all the way, the edge of the quick release bar will release, allowing you to fit the band between the watch lugs, against the watch body.
Ensure the opposite end of the quick release lever is aligned with the hole in the lug, then release the lever with your fingernail. The other side of the quick release bar will snap into the opposite lug. Gently tug on the watch band to check that it is secure.
Changing the nylon band
To remove the nylon band from your PACE Pro, first undo the Velcro fastening on the end of the band that has the COROS logo. Once this is done, pull the nylon band through the bar until it is only attached at one end.
To remove the other end of the nylon band, use your fingernail to slide the quick release lever on the back of the watch band. Once the lever is pressed all the way, the edge of the quick release bar will release, and you can then pull the band away from the watch body.
To attach a new nylon band to your watch, follow these steps:
1. One end of the nylon band will have a quick release built in. Use your fingernail to slide the quick release lever until it is pressed all the way.
2. Once the lever is pressed all the way, this will release the bar, allowing you to attach one end of the bar against the hole in the watch lug. Then align the other end of the quick release bar to the opposite watch lug. Release the lever and let the bar snap into place. Gently tug on the band to check that it is secure.
3. The other end of the nylon band has two Velcro fasteners. First, with the Velcro undone, slide the entire band through the bar on the other side of the watch body.
Note: If you do not already have another spring bar on this side of the watch, please locate the spring bar in your nylon band packaging. Use your fingernail to press down on the lever in the middle of the spring bar, causing the bar to depress and fit between the watch lugs. Place one end of the spring bar into the watch lug, then release the lever to allow the other end of the spring bar to snap into place in the opposite lug.
4. Next, fold the band over the bar to your desired wrist size. Secure the nylon band by folding the edge with the COROS logo against the band. This will prevent the band from slipping out of the quick release bar.
Now you are all set and ready to use your PACE Pro nylon band!